Euri Posted February 16, 2019 Share Posted February 16, 2019 Form my experience so far: 1) German Observers cannot order artillery missions beyond 1000 meters - (Observation based on Al Bab mission of German Campaign. Not sure if it applies to all spotters) 2) US soldiers tend to overuse handguns in close quarters instead of assault rifles. 3) Syrians tend to abandon positions in buildings and run into the open if they are hit by artillery or HE or high caliber (over 20mm) fire. This is pure stupidity as it makes them much mover vulnerable. In general the AI tends to retreat more easily than CMSF1 which makes missions much easier 0 Quote Link to comment Share on other sites More sharing options...
Howler Posted February 17, 2019 Share Posted February 17, 2019 Only the US campaigns have been updated. This could be the issue with your first point. As for your last point, the pathfinding was tweaked in the 2.01 patch. If you have applied this patch then welcome to the club - the evasion/withdraw/retreat/etc. failings are what they are. It's more noticeable in close environments. No forthcoming corrective patch is expected. 0 Quote Link to comment Share on other sites More sharing options...
General Jack Ripper Posted February 17, 2019 Share Posted February 17, 2019 (edited) 15 hours ago, Euri said: 1) German Observers cannot order artillery missions beyond 1000 meters - (Observation based on Al Bab mission of German Campaign. Not sure if it applies to all spotters) Create a test map, open, flat, 2k by 2k, then see if you can call in an artillery mission further than 1000 meters. Make sure the weather is set to clear. 15 hours ago, Euri said: 2) US soldiers tend to overuse handguns in close quarters instead of assault rifles. I see them walking around with pistols in their hands, but when they shoot they switch back to the carbine unless they are very low on ammo. 15 hours ago, Euri said: 3) Syrians tend to abandon positions in buildings and run into the open if they are hit by artillery or HE or high caliber (over 20mm) fire. This is pure stupidity as it makes them much mover vulnerable. In general the AI tends to retreat more easily than CMSF1 which makes missions much easier Tell that to the fanatical SF and Combatants I shelled repeatedly during Ash Shammas: https://youtu.be/nTTDoXY0CQA Edited February 17, 2019 by General Jack Ripper I use too many commas. 0 Quote Link to comment Share on other sites More sharing options...
General Jack Ripper Posted February 17, 2019 Share Posted February 17, 2019 8 hours ago, Howler said: Only the US campaigns have been updated. This could be the issue with your first point. Nonsense. 8 hours ago, Howler said: As for your last point, the pathfinding was tweaked in the 2.01 patch. If you have applied this patch then welcome to the club - the evasion/withdraw/retreat/etc. failings are what they are. It's more noticeable in close environments. More nonsense. 2.01 patch had nothing to do with unit pathfinding: ********************************v2.01 PATCH NOTES********************************CAMPAIGNS AND SCENARIOS- The Semper Fi Syria campaign now only requires the USMC Module.TO&E- Various minor adjustments.- G-36 rifles removed from some Dutch vehicle crews.- Stingers and Stinger teams removed from British Army.QUICK BATTLES- Numerous adjustments to normalize equipment available to the branches of different nations. For example, tanks were removed from service Infantry branches, and added tanks to service armored/mech infantry branches.- Unconventional Infantry now have access to technicals.- Several Quick Battle maps were updated.BUG FIXES- All on-map mortars can now be properly used in indirect fire missions.- Spies are once again stealthy, based on Civilian Density.- Equipment adjustments to Marine, Dutch, and German soldier models.- Many minor art fixes.- Fixes to misplaced crewmembers.- Fixes for incorrectly assigned floating icons.- Linear assembly tool now works properly with ditches.- When opening a map from CMSF1 in CMSF2, ditches will no longer convert to wire fences.- Various crash and hang fixes.MISC-Updated base game manual PDF, with a fortifications chapter that explains use of IEDs. 8 hours ago, Howler said: No forthcoming corrective patch is expected. Oh please. 0 Quote Link to comment Share on other sites More sharing options...
Sgt.Squarehead Posted February 17, 2019 Share Posted February 17, 2019 17 hours ago, Euri said: 3) Syrians tend to abandon positions in buildings and run into the open if they are hit by artillery or HE or high caliber (over 20mm) fire. This is pure stupidity as it makes them much mover vulnerable. In general the AI tends to retreat more easily than CMSF1 which makes missions much easier I'd be willing to bet this down to them being rubbish troops, ie: poor soft factors in the editor, being applied to an already poor quality formation. 0 Quote Link to comment Share on other sites More sharing options...
Howler Posted February 17, 2019 Share Posted February 17, 2019 (edited) @General Jack Ripper , some have reported issues regarding pathfinding. Posts describing the less than perfect placement of the 'withdraw' waypoint, particularly in urban maps, are all over this board. You, yourself, recently posted a 'bug' regarding pathfinding on this very forum. You were less than civil in your response to me there too. CMSF2 is only expecting the updated NATO campaigns which are to be released as they become ready. The other titles are expecting the CMSF2 pathfinding algorithm to be made available real soon now to paraphrase BFC on it's imminent forthcoming release. What is expected will be title specific corrections along with a toning down of the 'flight' behavior which many have reported as problematic when it occurs to units in protective cover such as foxholes, buildings, bunkers. trenches, etc. I'm not sure what posting the 2.01 release notes was intended to achieve. Try explaining it to me again without using the word nonsense as your sole response. Edited February 17, 2019 by Howler 0 Quote Link to comment Share on other sites More sharing options...
Howler Posted February 17, 2019 Share Posted February 17, 2019 11 hours ago, Howler said: No forthcoming corrective patch is expected. 2 hours ago, General Jack Ripper said: Oh please. Are you saying there's something in the works for CMSF2? This is news to me as my expectations were simply the NATO campaigns as they were completed. 0 Quote Link to comment Share on other sites More sharing options...
IICptMillerII Posted February 17, 2019 Share Posted February 17, 2019 4 minutes ago, Howler said: The other titles are expecting the CMSF2 pathfinding algorithm to be made available real soon now to paraphrase BFC on it's imminent forthcoming release. What is expected will be title specific corrections along with a toning down of the 'flight' behavior which many have reported as problematic when it occurs to units in protective cover such as foxholes, buildings, bunkers. trenches, etc. I think the confusion might be over the upcoming patches and what they entail. As far as I know, the patches will have title specific fixes, as well as overall engine fixes. For example, it has been mentioned that the BAR and Bren guns in the WWII titles will return to firing bursts at long range while stabilized. This is obviously exclusive to the WWII titles. The big overall engine fix will be to the TAC AI abandoning its positions while under direct or indirect HE fire. This fix has already been applied to the release of CMSF2, so the behavior we are seeing in CMSF2 is what we will see in all other 4.0 titles once the patches are released. I personally think it is a great improvement over the base 4.0 behavior. What is not currently 100% clear is whether or not there will be a title specific patch for CMSF2 along with the rest of the patches. I suspect not, though I have no firm proof to back this up. Just my hunch. 1 Quote Link to comment Share on other sites More sharing options...
Howler Posted February 17, 2019 Share Posted February 17, 2019 @IICptMillerII +1 0 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.