weapon2010 Posted January 1, 2018 Share Posted January 1, 2018 ok how do I get this bridge to be above the water and look normal? https://imgur.com/a/vFY7U 0 Quote Link to comment Share on other sites More sharing options...
Warts 'n' all Posted January 1, 2018 Share Posted January 1, 2018 (edited) Hard to tell from that pic. Need to know what kind of bridge you are using. Edited January 1, 2018 by Warts 'n' all 0 Quote Link to comment Share on other sites More sharing options...
weapon2010 Posted January 1, 2018 Author Share Posted January 1, 2018 the bridge in that pic is a destroyed wooden bridge, does it matter?I just want to put 2 bridges over each roadway in pic, the bridges go underwater which I don't want https://imgur.com/a/waFrp 0 Quote Link to comment Share on other sites More sharing options...
MOS:96B2P Posted January 1, 2018 Share Posted January 1, 2018 (edited) @weapon2010 I use the direct elevation and elevation lock until it looks the way I want. Use on bridge end point action squares and on water squares. Also page 93 of the 4.0 Engine manual may help some. It is talking about large bridges but some of the pointers are still applicable. Edited January 1, 2018 by MOS:96B2P 1 Quote Link to comment Share on other sites More sharing options...
A Canadian Cat Posted January 2, 2018 Share Posted January 2, 2018 Two things are important. That the water squares are at a lower level than the ground and the ends of the bridge are resting on land squares of the same height. 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.