EricM Posted October 16, 2000 Share Posted October 16, 2000 I am playing the westwall scenario as American. I sent one rifle squad and one engineer to assault a pillbox. The assault was successful but one of the units somehow ended up in/on top of pillbox and does not show up. The only way I know they are there is when I click on the LT. the red in contact runs to the pillbox. I tried the transparent building command but no luck. How do I give commands to this unit or get them to show up? When I click where they are all I get is the pillbox with the message it is knocked out. Thanks for the help. Eric Link to comment Share on other sites More sharing options...
Guest TURBO Posted October 16, 2000 Share Posted October 16, 2000 Eric Use shift v for vehicles and i think this will remove the bunker so you con give orders to your squads. Link to comment Share on other sites More sharing options...
catullus Posted October 16, 2000 Share Posted October 16, 2000 Or better: Make an area. By dragging a rectangle with the mouse, you'll mark every friendly unit in the area. Or is it all units under your command? (Dead units are not marked, don't know about captured and broken ones.) Whatever, area select should do it, then you can shift-click to deselect in case you marked too many. C. Link to comment Share on other sites More sharing options...
Maastrictian Posted October 16, 2000 Share Posted October 16, 2000 Using the plus and minus keys (on the main keyboard, not the number pad) will cycle through all your units as well. This will get dead and alive units. --Chris Link to comment Share on other sites More sharing options...
Recommended Posts