86smopuim Posted August 18, 2007 Share Posted August 18, 2007 how to place units during setup. is this not possible with cmsf? 0 Quote Link to comment Share on other sites More sharing options...
SlapHappy Posted August 18, 2007 Share Posted August 18, 2007 You have to click on a unit, click on a "move" order and then click where you want the unit placed....within the restricted zones allowed for setup, of course. Don't worry, had me stumped for awhile too. 0 Quote Link to comment Share on other sites More sharing options...
86smopuim Posted August 18, 2007 Author Share Posted August 18, 2007 danke! 0 Quote Link to comment Share on other sites More sharing options...
Lurker765 Posted August 18, 2007 Share Posted August 18, 2007 How do you tell if a unit is padlocked into position and not allowed to move? I couldn't figure it out in the al Fubar scenario without going into the editor. 0 Quote Link to comment Share on other sites More sharing options...
KNac Posted August 18, 2007 Share Posted August 18, 2007 cause it's not in the set up area 0 Quote Link to comment Share on other sites More sharing options...
Lurker765 Posted August 18, 2007 Share Posted August 18, 2007 The al Fubar scenario didn't have any setup zone at all as far as I can tell. So, none of my units could move. Does that mean you can't padlock a unit in the middle of a setup zone? 0 Quote Link to comment Share on other sites More sharing options...
Elmar Bijlsma Posted August 18, 2007 Share Posted August 18, 2007 As a designer? Not sure, never was one for scenario design. But wouldn't it be just as easy to make the location where you want the tank to stay a non setup zone tile? btw, I continue to be surprised that there are people who can't figure unit placement out. It just seems so obvious to me. 0 Quote Link to comment Share on other sites More sharing options...
Lurker765 Posted August 18, 2007 Share Posted August 18, 2007 It was obvious to me until that particular scenario. The no colored setup zones for any units was confusing 0 Quote Link to comment Share on other sites More sharing options...
KNac Posted August 18, 2007 Share Posted August 18, 2007 Originally posted by Lurker765: Does that mean you can't padlock a unit in the middle of a setup zone? Right. Just do what Elmar suggests 0 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.