semmes Posted January 24, 2018 Share Posted January 24, 2018 So... I've been trying to find something about it... E-W and NE-SW bridges are missing? or is this a bug in my installation, because I cannot find anything about how to rotate them. Thanks. Than the Frenchmen didn't knock our masts away was not my fault. Collingwood. 0 Quote Link to comment Share on other sites More sharing options...
Pete Wenman Posted January 24, 2018 Share Posted January 24, 2018 (edited) This is what you should see Use the arrows at the top to rotate a bridge through 90 degree increments and the diagonal button for bridges on NW-SE axis etc, again using arrows at top to rotate as required The editor changes to this P Edited January 24, 2018 by Pete Wenman 0 Quote Link to comment Share on other sites More sharing options...
semmes Posted January 24, 2018 Author Share Posted January 24, 2018 Thanks. Funny, I've been rotating houses. And then you need 3 trenches to change the facing, correct? 0 Quote Link to comment Share on other sites More sharing options...
Pete Wenman Posted January 24, 2018 Share Posted January 24, 2018 7 minutes ago, semmes said: And then you need 3 trenches to change the facing, correct? Yep, that is correct p 0 Quote Link to comment Share on other sites More sharing options...
General Jack Ripper Posted February 11, 2018 Share Posted February 11, 2018 On 1/24/2018 at 3:46 PM, semmes said: And then you need 3 trenches to change the facing, correct? You only need two. 0 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.